6
2-1 Preparation Of Mower
NOTE: The mower deck PTO belt must be removed
from the electric clutch before continuing with the
installation. Refer to your Cub Cadet mower owner’s
manual for instructions on PTO belt removal.
From the underside of the engine, disconnect the wiring
harness attached to the electric clutch. Remove the bolt
and electric clutch from the mower. Remove the D-drive
spacer using an arbor press or equivalent. On removal,
adjacent bearing OUTER race must be supported or
bearing damage may occur. Refer to Figure 2-1a.
Once the Engine Pulley Bushing P#(S0210) is installed,
reattach the clutch assembly to the mower and then
review Figure 2-1c.
The engine pulley assembly must be installed using an
arbor press or equivalent. During installation, opposite
bearing inner race must be supported or bearing
damage may occur. Refer to Figure 2-1c.
To assemble and fasten the Engine Pulley, align Pulley
hole to the Engine Pulley Bushing and fasten using (1)
Clamp Washer P#(K0278), (1) 7/16”-20 x 3-3/4” HHCS
P#(K0350) and (1) 7/16” helical spring lock washer
P#(K0140). Torque the bolt to 55ft./lbs. Refer to
Figure 2-1d for reference.
NOTE: Replace the mower deck PTO belt removed at
the beginning of this section.
Remove the rear bumper and hardware from the mower
as shown in Figure 2-1e.
Section II - INSTALLATION FOR USE
Remove
Rear Bumper
Figure 2-1a
Figure 2-1e
Engine Pulley Bushing Installation
Figure 2-1c
Electric Clutch
Figure 2-1d
Engine Pulley Assembled Into Electric Clutch
Engine Pulley
Bushing
Hex Bolt
Lock Washer
Pulley
Bushing
Number
Located
Here
Figure 2-1c
Clamp Washer
Pulley
To Next Page
Loading...
