MTB/ ROAD BIKE/ TREKKING
•
a) On racing bike brakes:
Shimano und Sram:
•
Move the lever upwards.
•
•
b) Campagnolo:
There is no lever on the brake:
To release press the pin on the brake lever
from inwards to outwards.
At the same time pull on the brake lever
slightly.
4. Loosen the wheel hubs.
•
•
Open the quick release on your road wheel
(see also Chapter 8.8 Quick Releases)
Turn the locknut enough to allow suci-
ent room on the axle. With other types of
clamping.
5. Remove the road wheels from the frame
and forks.
•
•
Front wheel: Lift the bike up by the handle-
bars and withdraw the road wheel from the
front fork dropouts.
Rear wheel: Lift the bike up slightly at
the back and press the gear mechanism
backwards. In this position push the rear
wheel gently in the direction of the dropout
openings.
6. After removing place the bike carefully
on its left hand side
Danger of material damage!
With no rear wheel the frame and/or the
gear mechanism can become damaged.
•
After removing the rear wheel lie the bike on
its left side or use a suitable assembly stand.
To t your road wheels.
Fit the rear wheel rst.
1. a) Inserting the rear wheel
•
Lift up the bike rear,
To Next Page
Loading...
Need help?
General
