Cuddeback IR - Arming and Display Information

Step 5: Checking the Cuddeback
®
IR
Detection Zone
1. Turn the rotary knob to the Test position. Close the
cover and tighten the thumb screw. Put Cuddeback
®
IR
back onto the tree bracket. (Note: For a more
convenient method to enable test mode, see “Step 7 –
Checking Cuddeback
®
IR Display Information”).
2. Walk back and forth in front of Cuddeback
®
IR . The
red LED will illuminate when
Cuddeback
®
IR ’s
sensor has detected you. Using this method you can
accurately position your Cuddeback
®
as desired.
Step 6: Arming the Cuddeback
®
IR
You can program the Cuddeback
®
IR to record still images,
or still images AND videos. Turn the rotary knob to either
the Video Off setting or the Video On setting as desired.
The settings represent the amount of time Cuddeback
®
IR
will wait before it is armed and ready to take another
image. This delay time prevents multiple images of the
same animal. Here is our recommendation for the various
Armed settings:
a. Under 30 seconds – game trails
b. 1 and 3 minutes – scrapes, food plots or feeders
When fi rst armed,
Cuddeback
®
IR will display the
indicated delay for 5 seconds and then begin counting
down from 30 to 0. When the counter reaches 0,
Cuddeback
®
IR will arm and be ready to record images.
When Cuddeback
®
IR detects a subject and takes a
7