Appendix A: Parameters
Setting Cuddeback
®
IR Parameters
Some Cuddeback
®
IR model’s features can be changed
by the user. Cuddeback
®
IR can also be programmed to
become a time-lapse camera. (Note: In the text that
follows, the underlined items are default settings. For
most users these settings are not required, and they can
leave PO set to 0.)
Step 1: Enable or disable parameters OR select
time-lapse operation
First you must enable parameters:
1. Rotate knob to MENU
2. Press A until P0:0 is displayed. P0 indicates
Parameter Zero, which is the parameter
ON/OFF control.
3. When P0:0 is displayed, press the B key to select
from these 3 options:
P0:0 = parameters are OFF and set to defaults
(recommended for most users)
P0:1 = parameters are ON and can be changed
as desired
P0:tL = time-lapse mode (explained on page 21)
Step 2:
Press the A key to display P1 (strobe power)
P1 controls the Cuddeback
®
strobe camera’s illumination.
This applies to strobe cameras only. Select available
settings by pressing the B key:
19
To Next Page
Loading...
