Cuddeback IR - Press the a Key to Display P6 (FAP Mode); Press the a Key to Display P7 (Zone Control); Press the a Key to Display P8 and then P9 (Camera ID)

Select available settings by pressing the B key:
P5:1 = standard resolution 5MP
P5:2 = high-quality 20MP
Step 7:
Press the A key to display P6 (FAP Mode)
P6 enables or disables a super-fast camera delay, called
Fast-as-Possible, or FAP. When P6 is on, the camera will
re-arm immediately after the image or video is saved to the
SD card. This can result in a camera delay of 1 to 2 seconds.
When P6 is on, the 5-second camera delay position becomes
FAP. The remaining dial positions are not affected.
Note: Using FAP mode can result in blank images.
Press B to enable or disable FAP:
P6:0 = FAP mode disabled
P6:1 = FAP mode enabled
Step 8: Press the A key to display P7 (Zone Control)
P7 controls the Cuddeback
®
IR Zone Control setting.
Select available settings by pressing the B key:
P7:0 = when Zone Control shutter is up (centered)
P7:
1 = when Zone Control shutter is down (wide angle)
Step 9: Press the A key to display P8 and then P9
(camera ID)
This camera has a 4 digit camera ID fi eld that is printed
on the image footer. Parameter P8 is used to set the low 2
digits, and P9 is used to set the high 2 digits. For example,
if you want CAM ID = 1234, set P8 to 34 & set P9 to 12.
For each Parameters use the B key to set a value from 0
thru 99. If 0 is selected, the ID number will not be printed.
21