Stopping conditions and recovery steps | JetScan
®
MPX 8200 strapping and corner module | 19
4. Remove the jammed document and any document that is nearby and at risk of
causing an additional jam. Use care when removing documents in the strap head
area.
Burn hazard. Hot surface below strap head.
Do not touch.
See the Strap head section for more information.
5. Press Jog Forward if the button is shown on the screen to move (jog) the transport
path forward to free a document. Inspect the surrounding area for obstructions or
foreign objects and remove them.
6. Press Prev (previous) or Next in the bottom right corner of the screen to select the
next jam and repeat steps 4-5. Continue this process until all jams are cleared.
7. Close the upper-front access door and the lower paper-roll access door.
Once Flush is pressed, the screen identifying the jam location disappears, and
it cannot be recalled.
8. Press Flush to ensure the transport path is clear. Motors momentarily run and then
automatically time out and stop.
9. A Strapper Reset screen appears if a reset procedure is required. Press Reset. The
screen refreshes when the procedure is complete. Press OK to continue.