DO NOT operate cable puller in wet or damp locations. DO NOT
expose to rain.
DO NOT operate in an explosive atmosphere.
DO NOT use cable puller as a hoist or for lifting, supporting or
transporting people or loads. Use only for its intended purpose as
a cable puller.
DO NOT wrap rope around any body parts. DO NOT wrap rope
around wrists.
ALWAYS keep rope away from operator’s feet.
DO NOT exceed load rating of cable puller, rope, or accessories.
ALWAYS inspect rope before each use.
ALWAYS disconnect cable puller before servicing.
ALWAYS plug the Model 1450 Cable Puller into a grounded
receptacle with a 20 amp GFCI protected circuit. DO NOT modify
the plug provided with the Model 1450 Cable Puller.
ALWAYS inspect the structural integrity of any supports, conduit,
anchoring system etc. that will hold the cable puller during the
pull. These supports should be able to withstand the maximum
pulling force of the cable puller plus a safety factor of 3:1.
Example: 10,000 lb. puller should be anchored to a support that
can withstand 30,000 lbs. of pull.
When using the Model #2280 floor mount or Model #2281 chain
mount, ALWAYS ensure the cable puller is properly pinned onto
the floor/chain mount and that the floor/chain mount is properly
secured before operating. ALWAYS attach the Model #2281 chain
mount to supports that are at least 2" and not more than 10" wide.
See Figure 4
DO NOT mount the Model #2281 floor/chain mount to square
columns or I-Beams. The mounting chains will not tighten properly
on these structures.
RETAIN SAFETY INFORMATION
4
4
IMPORTANT SAFETY INFORMATION
This manual should be read and understood by all personnel who operate
or service this Puller. Failure to understand how to safely operate and
service this unit could result in serious injury or death. This unit should
only be operated and serviced by qualified personnel.
DANGER
WARNING
WARNING
WARNING
DANGER
DANGER
WARNING
WARNING
Figure 4
OK TOO WIDE
To Next Page
Loading...