FLOOR/CHAIN MOUNT
18
The Model #2280 floor mount and #2281 chain mount are made to fit the
Current Tools Model #1450 Cable Puller and can be mounted using two
different procedures as noted on pages 18 through 22.
PROCEDURE #1
Mounting to a concrete floor
(Model #2280 floor mount)
Safety Information
1. ALWAYS mount to a smooth,
flat concrete floor with a
minimum 3000 psi rating.
2. Mount only to a concrete floor.
NEVER mount to cinder blocks,
brick, etc.
3. Wedge anchors must be at least
12" away from edge of concrete.
4. ALWAYS use new anchors.
NEVER REUSE ANCHORS.
5. Use only 5/8" x 6" wedge anchors or equivalent with a tension and shear
rating of 2,500 lbs. (Current Tools part #8045-3)
6. ALWAYS wear eye protection when installing anchors.
WARNING
ALWAYS place the Model #2280 floor mount close to the conduit. This will
reduce the possibility of injury should the rope break. See Figure 18a.
Figure 18a
CAUTION
PLACE CLOSE TO CONDUIT
To Next Page
Loading...