IMPORTANT SAFETY INFORMATION — CONTINUED
6
Rope should approach
capstan as shown in
Figure 6a
ALWAYS use black roller
to guide rope so that the
operator stands at a 90˚
angle to the cable puller
and out of the direct line
of tight pulling rope. See
Figure 6b.
ALWAYS wrap rope beginning
at housing end of capstan as
shown in Figure 6b.
To help avoid rope overlap,
rope should approach capstan
at 90˚ angle. See figure 6b.
ALWAYS make sure the puller
motor has completely stopped
before switching from low
to high speed or high to low
speed. A puller ready light is
mounted in the electronics box
and will illuminate green when
the motor is ready for use.
DO NOT alter this cable puller.
Doing so will void the warranty.
Guards and safety features are
provided for your protection.
DO NOT use an extension cord longer than 100 ft. Extension
cord should be a minimum of 12 gauge wire with ground.
Wear eye protection when operating cable puller.
Inspect all components of the pulling system before beginning
any cable pull. This includes the pulling system ( cable puller,
boom, etc. ) and any accessories ( sheaves, swivels, pins, etc. )
Replace any worn or defective components.
Be careful during assembly and disassembly of the boom
components. Keep pins in place to avoid uncontrolled
movement of boom components. Have control of boom
components before removing any pins.
CAUTION
CAUTION
CAUTION
CAUTION
WARNING
Figure 6b
Figure 6a
SIDE
VIEW
PULL
DIRECTION
MAXIMUM
10˚
MAXIMUM
10˚
OVERHEAD
VIEW
TO
OPERATOR
BLACK
ROLLER
PULL
DIRECTION
90˚
CAUTION
CAUTION
To Next Page
Loading...