Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
60607 GOOSENECK HITCH
FIGURE 1
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
SAFETY CHAIN LOOP ASSEMBLYCM-C60-CLA21
2" x 3" SAFETY CHAIN LOOPCM-C60-CL11.1
U-BOLT SPRINGCM-C60-S21.2
NYLOCK HEX NUT
1_2 - 1321.3
FW,1/2 SAE,ZPFW12SAE
41.4
WASHER3/8"
22
FLAT HEAD C'SUNK CAP SCREW#10-32 x 3/4
33
NYLOCK HEX NUT#10-24 NYLOCK HEX NUT14
HEX HEAD FLANGE SCREW#10-24 x 1.25 HHFS1
5
TURNOVER BALL COMPLETECM-C60-B16
CAST LOCK PINCM-C600-CLP1
7
.375" HANDLE RODCM-C60-R18
7.5 LB COMPRESSION SPRINGCM-C60-CS
19
VINYL HANDLE GRIPCM-C60-H
110
RUBBER COVERCM-C60-RC
111
.300" U-SHAPED EDGINGCM-UE1
112
3.75 DIA. x .375" CHROME RINGCM-C600-CR113
TOP VIEW OF HITCH
BOTTOM VIEW OF HITCH
USE 60607 CENTER SECTION TO
LOCATE AND DRILL SAFETY
CHAIN ATTACHMENT HOLES
HIGH RIB SECTION
LOW RIB SECTIONS
HOLE LOCATION
FOR SAFETY CHAIN
ATTACHMENTS
USE AS NEEDED FOR
PROPER PULL LENGTH
WHEN BALL IS NOT IN
USE, INSERT SUPPLIED
RUBBER COVER
PAGE 2
8
10
11
9
2
6
1.1
1.4
1.3
1.2
2/26/2013
7
12
13
3
WARNING DO NOT invert ball when carrying
heavy loads on 2 wheel drive trucks. The ball may
hit the top of the differential,brake lines, or sensors.
(NOTE: Do not invert ball on any Toyota Tundra Models)
12
U-EDGING INSTALLED
AROUND EDGE OF 4" HOLE
IN TRUCK BED
5
4
To Next Page
Loading...
Need help?
General
