Blue Ox Rev. A, draft #1 [3 August 2007]
Curtis 1253 Manual, Rev. F
iii
CONTENTS
1. OVERVIEW ..............................................................................1
2. INSTALLATION AND WIRING ...........................................3
Mounting the Controller .....................................................3
Low Current Connections....................................................5
High Current Connections ..................................................6
Wiring: Standard Configuration..........................................7
Wiring: rottles ...............................................................11
Contactor, Switches, and Other Hardware .........................13
3. PROGRAMMABLE PARAMETERS .....................................15
Speed Parameters................................................................16
Maximum Speed, SS1–SS4 .........................................16
rottle Maximum Speed ............................................16
Minimum Speed ..........................................................16
Acceleration Rate .........................................................16
rottle Parameters ............................................................16
rottle Type ...............................................................16
rottle Deadband ......................................................17
rottle Maximum ......................................................18
rottle Map ...............................................................20
Final Speed Request Parameters .........................................22
SS Add Mode ..............................................................22
Final Add Mode ..........................................................23
SS High Speed On ......................................................24
Fault Parameters .................................................................25
Lift Lockout Type ........................................................25
Lift Lockout, SS1–SS4 ................................................25
Lift Lockout, rottle ..................................................25
rottle Fault Detection ..............................................26
Startup Lockout...........................................................26
Undervoltage Parameters ....................................................27
Low Voltage Cutback ..................................................27
Low Voltage Cutback Rate ..........................................27
Contactor Control Parameters ...........................................27
Pump Contactor Control ............................................27
Contactor Pull-in Voltage ............................................27
Contactor Holding Voltage..........................................27
SS4 Delay ....................................................................28
Interlock Delay ............................................................28
Precharge .....................................................................28
Precharge Delay ...........................................................28
CONTENTS