Custo Med Ergometer ec3000 - Selection of the Load Setpoint

Manual operation
Ergometer
ec
3000
3
-
2
3.2.
Selection of the load setpoint
The manual in
put of the load setpoint can only be executed with the operating mode
„manual“. It is indicated by the letter „P“ followed by the value of the current load
setpoint ( in W ).
By pressing the key
+
or
the load setpoint is increased by 5 W.
the load setpoint is decreased by 5 W.
The input area lies between 5 W and 995 W.
Notes:
1.
Th
e current load is being regulated to the target value by a gradient of
10 W / sec. The current load is displayed in the display field „CAPACITY“.
2.
The increment decreases from 5 W to 1 W per each step in the load range
below 20 W.