Custo Med Ergometer ec3000 - Programming of the Initial Capacity

Ergometer ec
3000
Training programs
5
-
19
5.4.2.3.
Programming of the initial capacity
Each pulse
-
steady
-
state
-
program starts with a two
-
minute warm
-
up time and the initial
capacity P0.
It is required for the entry of the initial capacity that the display field „CAPACITY“ is
flashing.
By pressing the key
+
or
the capacity is increa
sed
or
it is decreased.
By pressing the key „START/PAUSE“
By pressing the key „STOP“ the
the current value is taken over and it is
programming is finished.
transmi
tted for the entry of the initial capacity.
START
PAUSE
or
STOP