Custo Med Ergometer ec3000 - 4 Remote Operation; Selection of the Remote Operation

Ergometer ec
3000
Remote operation
4
-
1
4.
Remote operation
4.1.
Selection of the remote operation
The operation mode „Remote“ is entered when the correct transmission of telegrams is
detected with the remote interface.
The ergometer has the following remote interfaces:

Serial interface

CAN
-
Bus
The
localization and configuration of the interfaces is described in the Technical Manual
of the ergometer.
The remote operating state can be accomplished from the main menu. The
accomplishing of this operating state can be recognized by the word „PC“ in the
„INFO“
field of the ergometer.
The number indicates the target capacity set by the PC.