Custo Med Ergometer ec3000 - Page 34

T
raining programs
Ergometer ec
3000
5
-
16
Program
selection
Program
type selection
“PSST”
Setting of
initial
capacity P0
Setting
of
pulse rate
Setting
of
duration
Key
“PROG”
Key
“START/PAUSE”
Key
“START/PAUSE”
Key
“START/PAUSE”
Key
“STOP”
Key
“STOP”
Key
“STOP”
Key
“STOP”
Key
“START/PAUSE”
ec_psst_seq01.cdr
17. Juli 2002
Process of programming
At first the program is determined by selection
of the corresponding program number
( cf. chapter 1.2.3 ).
„PSST“ must be selected as program type
for „pulse steady state programs“
( cf. chapter 1.4.2.2 ).
As warm
-
up the initial capacity for this
patient must be set
( cf. chapter 1.4.2.3 ).
Then the setting of the required
pulse rate is done
( cf. chapter 1.4.2.4 ).
Lately the duration of the training must be set
( cf. chapter
1.4.2.5 ).