and the description of device parameters see the following paragraphs.
PRINTER NAME and
FIRMWARE MODULE
RELEASE
PRINTING HEAD
STATUS
KEYS FUNCTIONS
DEVICE
STATUS
PRINTER
PARAMETERS
PRINTER SETTINGS
PRINTHEAD SELFTEST
1 •••••••••• 832
PRINTHEAD WORKING GOOD!
PRINTER TYPE ....................................PLUS4
PRINTING HEAD TYPE ........................<type>
INTERFACE ..........................................RS232
PROGRAM MEMORY TEST.................OK
DYNAMIC RAM TEST...........................OK
EEPROM TEST.....................................OK
HEAD VOLTAGE [V] = 07,00
HEAD TEMPERATURE [°C] = 25
POWER ON COUNTER = 4
PAPER PRINTED [cm] = 40
Printer Emulation............................. : ESC/POS (TM)
RS232 Baud Rate ........................... : 115200 bps
RS232 Data Length......................... : 8 bits/chr
RS232 Parity ................................... : None
RS232 Handshaking ....................... : Xon/Xoff
Busy Condition ................................ : RxFull
USB Address Number ..................... : 0
USB Virtual COM............................. : Disabled
Print Mode ....................................... : Normal
Autofeed .......................................... : CR Enabled
Chars / inch ..................................... : A=20 B=15 cpi
Code Table [num] ............................ : 00
Font Type......................................... : International
Speed / Quality................................ : High Quality
Print Width....................................... : 104 mm
PaperEnd Buffer Clear .................... : Disabled
PrintHead Test PowerOn................. : Disabled
Print Density.................................... : 0%
[PUSH] to enter setup
[FAST PUSH] to skip setup
PLUS4 printer
SCODE. <code> - rel 1.00
FCODE. <code> - rel 1.00
46
To Next Page
Loading...
Need help?
General
