6/38
Sept.
2014
V3.1
CybTouch 8 PS User Manual
Language
Show Y1-Y2
position values
To browse through the available languages, simply touch Language on the screen.
Available languages are:
This function will display the Y1 and Y2 axes positions on the Bend Numerical Page (see
page 14).
• When set to no, the position of axis Y1 is displayed during the beam’s movements.
• When set to yes1, the positions of the beam’s axes are displayed during the beam’s
movements.
• When set to yes2, the positions of the beam’s axes are constantly displayed under the
angle/beam’s position line.
• EN English.
• BR Brazil.
• CN 中文.
• CZ Český.
• DE Deutsch.
• ES Español.
• FR Français.
• IT Italiano.
The list of available languages is subject to change and may increase over time.
Length Units
This parameter allows choosing between mm, inch and none for the length unit to be
used in the CybTouch.
Show page
L-alpha num
This preference is only available if the machine is equipped with the TouchProfile Mode
(optional) option. When set to yes, this parameter gives access to the L-Alpha Mode (see
page 27). This button
is then displayed on the TouchProfile Mode (optional) page.
Show bent part
This preference is only available if the machine is equipped with the TouchProfile Mode
(optional) option. This parameter, when activated, lets the operator see the state of the
part before and after the bend in the Manual Bend Sequencing page.
• NL Nederlands.
• TR Türkçe.
• TW 台灣.
When none is selected, the units are millimeters.
To Next Page
Loading...
