38/38
Sept.
2014
V3.1
CybTouch 8 PS User Manual
MSG nr. MeSSaGe deScripTion
E69 The machine is not indexed !
No limit
Before the machine is indexed, the NC doesn’t know where the
axes are. In manual page, movements are authorized but the
electronic stroke limits are not activated. Operator is responsible
for stopping axis movement before mechanical limit is reached.
E70 Progr. angle is smaller than the
die angle
The programmed angle is smaller than the die angle. Change die.
E71 Progr. angle is smaller than the
punch angle
The programmed angle is smaller than the punch angle. Change
punch.
E72 Depth safety The calculated angle causes the punch, material, and die to
collide and approach coining mode. Operator must confirm to
proceed.
E73 Collision backgauge-tool This message appears to warn that, with the parameters cannot
be entered as such, for they would cause a collision between the
back gauge and the tools. Check your parameters’ values.
E74 Beam error No [ ][ ][ ]
E75 Beam: static gains not found
E76 Error in the parameter beam
(you must correct it before
continuing)
E77 Error in the sequence
parameter (you must correct it
before continuing)
E78 RS232: parity error
E79 RS232: overrun
E80 RS232: framing
E81 RS232: noise
E82 PCSS event No xx
E83 PCSS error time out
E84 PCSS error checksum
E85 PCSS error buffer rec to small
E86 File access error There was an error when trying to access a file while
programming an option. Make sure that the code was entered
properly. If it is not working try and restart the NC. If the problem
persists, contact Cybelec.
E87 Unknown error An unknown error occurred while trying to program an option.
Contact Cybelec.
E88 RS232: port already open
E89 Solution not found This message indicates that the bending sequence automatic
search did not find any solution. Try to create the bending
sequence manually. If not possible, it means that this part is not
feasible on this machine.
To Previous Page
Loading...
