CyberPower CP900EPFCLCD - TROUBLESHOOTING

9
Typical Recharge Time
8 hours
Charging Current(Max.)
0.6A
User Replaceable Yes
Status Indicators
Indicators Power On, LCD Display
Audible Alarms On Battery, Low Battery, Overload
Communication
PowerPanel
®
Personal
Edition Software
Windows 8 / 7/ Vista / XP, and Server 2012 / 2008 / 2003, Linux
Management
Auto-Charger Yes
Auto-Restart Yes
USB interface Yes
TROUBLESHOOTING
Problem Possible Cause Solution
Circuit breaker button is
projecting from the back of
the unit.
Circuit breaker has
tripped due to an
overload.
Turn the UPS off and unplug at least one
piece of equipment. Wait 10 seconds, reset
the circuit breaker by depressing the
button, and then turn the U
PS on.
The UPS does not perform
expected runtime.
Battery not fully
charged.
Recharge the battery by leaving the UPS
plugged in.
Battery is slightly worn
out.
Contact CyberPower Systems about
replacement batteries.
The UPS will not turn on.
The on/of
f switch is
designed to prevent
damage by rapidly
turning it off and on.
Turn the UPS off. Wait 10 seconds and
then turn the UPS on.
The battery is worn
out.
Contact CyberPower Systems about
replacement batteries.
Mechanical problem. Contact CyberPower Systems.
PowerPanel® Personal
Edition is inactive.
The USB cable is not
connected.
Connect the USB cable to the UPS
unit
and an open serial port on the back of the
computer. You must use the cable that
came with the unit.
The unit is not
providing
battery power.
Shutdown your computer and turn the
UPS off. Wait 10 seconds and turn the
UPS back on. This should reset the unit.
Additional troubleshooting information can be found at www.cpsww.eu.
For more information, visit www.cpsww.eu.
Entire contents copyright ©2014 CyberPower Systems, Inc., All rights reserved. Reproduction in whole
or in part without permission is prohibited. PowerPanel® and PowerPanel® Plus are trademarks of