DOE Compliance Statement
This device complies with Energy Conservation Standards of the Energy Conservation Program issued by the U.S. Department of Energy in
accordance with 10 CFR Parts 429, 430 and 431, as appropriate, and the Energy Policy and Conservation Act, as amended, under the setup as
described below.
1. Plug the UPS into a grounded AC outlet and turn on the unit via the power switch on the LCD module.
2. Follow below steps to switch on Night Mode settings to save energy.
(a) Press the Menu button to enter Setup Menu and use Up/Down button to scroll to Night Mode Menu. Press Enter button to go
into the selected menu.
(b) Use the Up/Down button and Enter button to select the setting item and to complete the following setting.
i. Night Mode LCD Switch Off (Message on the display: LCD On/Off: Off)
ii. Night Mode LED Switch Off (Message on the display: LED On/Off: Off)
iii. Night Mode Switch On (Message on the display: Night Mode: On)
(c) Night Mode indicator (blue LED) on the LCD model will illuminate and the LCD and LED will turn off after a few seconds of
inactivity if above settings are set correctly. Pressing any button will activate the LCD and LED.
3. Charge the batteries for at least 12 hours while the UPS is turned on to ensure the batteries are fully charged by leaving the UPS plugged
into a grounded AC outlet under 0% load.
Note: (a) The first time you turn the UPS on, you will need to have it connected to AC power or it will not power up. (b) If the product has been
used, press Menu button to enter to Setup Menu and use Up/Down button to scroll to Advanced Setup Menu. Press Enter button to go into the
selected menu. Select the item “Back to Default”, choose “Yes” to restore the default setup of the unit and then starts from setup 1 described
above.
To Next Page
Loading...
