1. Sensitivity: Set the level of tolerance for Increase the UPS compatibility for local utility power condition.
High: The UPS will turn to battery power more often to provide the steady power supply to the connected equipment.
Low: The UPS will tolerate more fluctuations and turn to battery power less often
2. Battery Pack Numbers: This function provides the estimated UPS runtime using various numbers of battery The default setting is 0
3. Battery Lifetime: Show the batteries already used Reset the logger when battery module replacement or first time installation.
4. Firmware Version: Show the UPS version number.
The settable items are sorted by unit as in the following table:
Items Unit
1 Sensitivity
2 Battery Pack Numbers A
3 Battery Lifetime Year
4 Firmware Version
Step 3:
Press and hold the toggle for 4 seconds. When the icons blink, the value of each item can be changed by slightly pressing the toggle.
Step 4:
To save the value and return to general mode, press and hold the toggle for 4 seconds.
Note:
If the machine is left idle for over 30 seconds during setup, it will turn off the backlight and return to general mode automatically.
Note:
If user wants to return to general mode without saving changes, there are two methods:
1. Wait for the backlight to turn off
2. Press and hold the “Display” toggle for 10 seconds
TROUBLE SHOOTIMG
Problem Possible Cause Solution
Outlet do not provide power to
equipment
Circuit breaker has tripped due to
an overload.
Turn the UPS off and unplug at least one piece of equipment.
Wait 10 seconds, reset the circuit breaker by depressing the button,
and then turn the UPS on.
Batteries are discharged Recharge the unit for at least 4 hours
Unit has been damaged by a
surge or spike.
Contact CyberPower Systems about replacement batteries at
tech@cpsww.com
Uncritical outlets have turned off
automatically
due to an overload
Push the toggle button to make the uncritical outlets turn on.
The UPS does not perform
expected runtime.
Battery not fully charged. Recharge the battery by leaving the UPS plugged in.
Battery is degraded
Contact CyberPower Systems about replacement batteries at
tech@cpsww.com
To Next Page
Loading...
