18
INSTALLING THE CAR SEAT IN THE VEHICLE
Place the car seat on the appropriate seat in the vehicle.
• Always ensure that the entire surface of the backrest of the
car seat is placed fully against the backrest of the vehicle
seat.
• If the headrest of the vehicle is in the way, pull it out all
the way or remove it completely (for exceptions to this,
please refer to the section “CORRECT POSITION IN THE
VEHICLE”). The backrest will perfectly adapt to practically
any recline of the vehicle seat.
!
WARNING! The full surface of the backrest of the car
seat must be against the backrest of the vehicle. To
ensure maximum protection for your child, the car seat
must be in a normal upright position!
!
WARNING! Do not use any load bearing contact points
other than those described in the instructions and
marked in the child restraint.
To Next Page
Loading...
