28
STRAPPING WITH VEHICLE SEAT BELT
Place your child in the car seat. Pull the three-point belt right
out and feed it along the belt buckle (17) in front of your child.
The lap belt (19) should have been fed through the lower belt
guides (20) on both sides of the seat cushion (1).
Insert the belt tongue (18) into the belt buckle (17). It must
lock into place with an audible “CLICK”.
Next, place the lap belt (19) in the lower belt guides (20) of
the car seat.
Now pull the diagonal belt (21) rmly to tighten the lap belt
(19). The tighter the belt sits, the better it provides protection
from injury. On the side of the belt buckle (17), the diagonal
belt (21) and the lap belt (19) must be inserted together in the
lower belt guide (20).
NOTE! Teach your child from the start to always ensure that
the belt is tight and, if neccessary, how to tighten the belt
themselves.
!
WARNING! Never twist the belt.
!
WARNING! The vehicle belt buckle (17) must never
cross the arm rest. If the belt system is too long, the car
seat is not suitable for use in this position in the vehicle.
In case of doubt, please consult the manufacturer of
your vehicle.
!
WARNING! The lap belt (19) must run as low as
possible on both sides along your child’s groin to have
optimum effect in the event of an accident.
17
21
1
19
20
18
To Next Page
Loading...
Need help?
General
