4. Screw the A/V and coax cables into the E3 View monitor.
Qty.DescriptionItem
1Control board cable1
1A/V cable2
1Coax cable3
5. Plug IR receiver cable into E3 View Monitor.
Install back cover
Install the four screws securing the back cover to the console assembly using a Phillips screwdriver.
Qty.DescriptionItem
1Console Assembly1
1Back Cover2
4Screws3
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Wireless Heart Rate Board
Tools Required:
• Phillips screwdriver
• Flat head screwdriver
Page 184 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
