REMOVING AND REINSTALLING THE SEAT COVER
To remove please follow these steps, (reverse the instructions to reinstall)
1. Undo the belt buckle.
2. Unsnap the two Shoulder Pads from the harness.
3. If using the Infant Insert, simply unsnap the two snaps holding it
around the harness straps.
4. Pull the Headrest Cover over the edge.
5. Unsnap the two snaps connecting to the Backrest Cover.
6. Unsnap the two snaps creating the harness slot.
7. Unsnap the two black snaps holding the canopy fabric and push
canopy forward.
8. Unsnap the three gray snaps from the top of the plastic shell.
9. Unsnap two silver dual action snaps - same as for canopy straps.
10. Unthread fabric around European Belt Buckle and LSP devices,
then pull up over the top.
11. Pull forward and over the side wings, unsnap 2 gray snaps and 2
silver snaps connecting to Leg Support Cover, as well as 2 gray
snaps connecting to plastic shell and remove the Backrest Cover
12. Fully recline seat, unsnap opening for hip belt and lift fabric over the
side. Finally thread Crotch Buckle through the Crotch Buckle Pad.
BACKREST COVER
HEADREST
COVER
LEG SUPPORT
COVER
SHOULDER
PADS
31
The integrated Harness System cannot be removed from the seat.
NEVER remove or attempt to remove parts of the Harness System.
DO NOT damage, remove or dispose of any EPS foam.
NEVER use Infant Carrier without a properly installed Seat Cover.
CARE AND CLEANING (Continued)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
