Assembly
Page 5-4
Cybex Free Weight Owner’s Manual
Tools Required
5/16” Allen wrench
3/4” wrench
3/8” Allen wrench
Unpacking Power Cage and Power Cage Attachment Assembly
NOTE: T wo or three people are required to assemble the Power Cage and Power Cage Attachment.
1. Read and understand all instructions thoroughly before assembling the Power Cage and
Power Cage Attachment.
NOTE: Each step number in the assembly instructions tells you what you will be doing. The lettered
steps following each step number describes the procedure required. Do not continue with step 2
until you have carefully read all of the assembly instructions.
2. Verify you have received the appropriate shipping packages.
Verify you received the following: Power Cage Package - 5420-026, Right Side Subassembly -
5420-024-9x, Left Side Subassembly - 5420-025-9x, Attachment Subassembly - 5425A001-9x.
3. Unpacking
Carefully place Power Cage and Power Cage Attachment near area of installation.
Verify contents. See Figures 1 - 4.
NOTE: If ceiling height is less than 9 feet then Power Cage must be assembled in vertical
(standing) position.
•
•
•
A.
A.
B.
To Next Page
Loading...
