Cybex Free Weight Owner’s Manual
Service
Page 7-2
Grip Replacement
Bent Leg Ab Board
Check grips and replace worn grips as appropriate. This procedure is for replacing the grip located on the
Bent Leg Ab Board. See item H on the Bent Leg Ab Board Parts List sheet for location of grip.
1. Remove grip by carefully cutting it using a utility knife. NOTE: Be sure that all of the grip is removed.
2. Slide new grip onto bar.
Incline Bench
Olympic Bench Press
Check grips and replace worn grips as appropriate. This procedure is for replacing the grips located on
the Incline Bench and the Olympic Incline Bench. See the appropriate Parts List sheet for location of the
appropriate grip.
1. Remove grip by carefully cutting it using a utility knife. NOTE: Be sure that all of the grip is removed.
2. Place a generous amount of super glue inside new grip.
3. Slide grip into place. NOTE: The glue will set fast. If you do not place the grip on properly, then
repeat this procedure.
45 Degree Back Extension
Dip/Chin Station
Leg Raise Chair
Check grips and replace worn grips as appropriate. This procedure is for replacing any grip located on
the 45 Degree Back Extension, Dip/Chin Station or the Leg Raise Chair. See the appropriate Parts List
sheet for location of the appropriate grip.
1. Remove grip by carefully cutting it with a utility knife.
2. Spray lacquer inside grip.
3. Slide grip into place and work out all air bubbles.
Parts List and Diagrams
See the following pages for each machine.
To Next Page
Loading...
Need help?
General
