Assembly
Page 5-16
Cybex Free Weight Owner’s Manual
Tools Required
3/8” Allen wrench
3/4” wrench
Unpacking Squat Rack With Adjustable Stop Assembly
NOTE: Two people are required to assemble the Squat Rack With Adjustable Stop Assembly.
1. Read and understand all instructions thoroughly before assembling the Squat Rack With
Adjustable Stop Assembly.
NOTE: Each step number in the assembly instructions tells you what you will be doing. The lettered
steps following each step number describes the procedure required. Do not continue with step 2
until you have carefully read all of the assembly instructions.
2. Verify you have received the appropriate shipping packages.
Verify you received the following:
Squat Rack Assembly without Adjustable Stop - 5570-001-9x.
Squat Rack Assembly with Adjustable Stop - 5571-0010-9x.
Adjustable Stop Assembly (only) - 5572-001-9x.
3. Unpacking.
Carefully place Squat Rack and Adjustable Stop (if applicable) near area of installation.
Verify contents. See Figures 1 and 2.
•
•
A.
A.
B.
To Next Page
Loading...
Need help?
General
