Cybex Pro
3
Treadmill Owner’s Manual
Operation
Page 3-5
Stopping the Treadmill
Press Stop once to pause your workout for 20 seconds (default setting) and to enter the Workout Review.
The belt will stop and the elevation will return to 0%, but all workout settings and data will remain in
memory for the pre-selected time. Press the Quick Start key within 20 seconds to continue your workout
at the speed and elevation where you left off. If the Quick Start key has not been pressed during the
20 second pause, workout data will be cleared and the display will change to Dormant Mode.
Press Stop a second time to interrupt workout data from cycling and to change the display to Dormant
Mode.
The function of the immobilization method: The purpose of
immobilizing the treadmill is to prevent unauthorized use. This can
be accomplished by removing the e-stop key from the console,
unclipping it from the cord and putting it in a non-accessible place.
See Figure 2.
The emergency dismount: Follow the steps listed below if you
experience pain, feel faint or need to stop your treadmill in an
emergency situation:
1. Grip handrails for support.
2. Step onto the top steps.
3. Pull the e-stop key off the console.
The function of the emergency stop: The e-stop key functions as the
emergency stop. In an emergency situation, remove the e-stop key from
the console and the treadmill will come to a stop. On the console, the
e-stop location looks like Figure 3.
Safety Sentry™
If you step off your treadmill during a workout, it may detect that you are not there. After the pre-selected
waiting period “run?” will appear in the center window for a few seconds then Safety Sentry will stop the
belt. If you press Quick Start within the time selected you can resume your workout. NOTE: If you are
less than 100 lbs. and you are not using Polar the treadmill may not detect you are there and cause the
treadmill to come to a stop. Safety Sentry is disabled above 11% grade. It can also be disabled by setting
SAFE time to “none”. If changes in elevation or speed occur while you are not there (such as during a
programmed workout) Safety Sentry resets its waiting period.
Figure 3
Figure 2
To Next Page
Loading...
Need help?
General
