CYBEX Pro3 - Page 53

Cybex Pro
3
Treadmill Owner’s Manual
Setup
and
Assembly
Page 5-7
Using the Allen wrench provided, tighten the two pivot screws on the handrail. See Figure 8.
9. Remove the left side panel.
Pull the left side panel away from the base. See Figure 9.
10. Arrange power cord.
Decide whether you will plug the power cord into an outlet near the front of the treadmill or the
back of the treadmill. Follow the corresponding routing procedure below. NOTE: Do not plug in
the power cord at this time.
B.
A.
A.
Figure 9
Left Side Panel
Figure 7
Pivot
Screws
Figure 8
3