The PSX, via a separate 4-pin DIN plug, may also be connected to the
Mission PCM II compact disc player. In doing so, the analogue section of
this unit will be provided with a highly regulated and clean DC power
supply, which will in turn enhance its aortic quality. With this arrangement
the internal power supply of the unit will be dedicated to other sections,
such as the Servo, Digital circuitry, and the Display control.
The PSX is housed in a similar case to that of your amplifier. The only
control provided is the power on/off switch, situated on the front panel. On
the rear panel there is an umbilical cord for connection to the Cyrus II or
767 LFAU dedicated PSX input. There is also a 4-pin DIN socket for
connection to the PCM II.
NOTE:
1. To ensure satisfactory system upgrade, it is essential that your dealer or
the Mission service organisation make certain adjustments to your Cyrus II
or 767 LFAU before connecting the PSX power supply.
2. Once the Cyrus II or 767 LFAU has been adjusted for use with the PSX,
the power amplifier will not function without the PSX connected and
switched on.
3. Upgrading the PCM II with the PSX does not require any prior
adjustments.
INSTALLATION
MAINS SUPPLY
A label at the rear of your PSX power supply shows the appropriate mains
supply voltage and fuse rating of the unit. If the mains supply voltage of
your area is different contact your dealer or the Mission service
organisation.
The PSX is connected to the mains supply via an IEC socket and the mains
cable. The IEC socket has an integral mains fuse. When connecting the
mains supply, ensure that the cable is connected to the PSX first.
To Next Page
Loading...
