relevant source is at fault. Check input and loudspeaker connections of the
channel without sound.
Check loudspeaker fuse if any.
Interchange the loudspeaker connections between Left and Right channels.
Observe whether the fault changes over. If so then the amplifier has a
faulty channel. If the fault stays in the same channel, then the loudspeaker
is at fault.
NO SOUND FROM ANY SPEAKER
Check that the amplifier is On.
Check the sound on the other sources.
If problem persists then the internal fuses of the amplifier may have blown.
Refer the amplifier to your dealer.
HUM OR CRACKLING SOUND FROM ONE OR BOTH SPEAKERS
Check there are no faulty connections along the speaker cables and the
interconnect cables.
Check to make sure the turntable ground is connected to the GND terminal
on the rear panel.
Check that the turntable interconnect is not dressed next to any mains
leads.
MUSIC REPRODUCTION SOUNDS HOLLOW AND STRANGE
Check the speaker cables are connected to the amplifier and speakers
correctly.
If in Phono mode, check the cartridge has been wired correctly.
OPERATING INSTRUCTIONS
To Next Page
Loading...
