Cyrus 1 - Fuse, Siting, and Connection

• BLUE = Neutral
• GREEN/YELLOW. = Earth
The Brown wire must be connected to the terminal that is marked "L" or
coloured RED. The Blue wire must be connected to the terminal that is
marked "N" or coloured BLACK. The GREEN/YELLOW wire must be
connected to the terminal that is marked with the letter "E" or coloured
GREEN or coloured GREEN AND YELLOW.
MAINS FUSE
Cyrus I:
• UK/Europe - 220/240V = T1A/20mm
• N.America/Far East - 100/120 = T1.6A/20mm
Cyrus II:
• UK/Europe - 220/240V = T1.25A/20mm
• N.America/Far East- 100/120V = T2.5A/2Omm
SITING THE AMPLIFIER
Your Cyrus amplifier can be sited as a free standing unit or stacked with
other units in an audio rack. However, since the power amplifier produces
a substantial amount of heat, positioning the unit at the bottom of the rack
should be avoided. Convected heat from the amplifier could adversely
affect other units stacked above, as well as overheat and damage your
amplifier.
The amplifier must NOT be sited near a source of heat or in a position
exposed to direct sunlight.
CONNECTIONS
Before making any connections to your amplifier, ensure that all units are
switched OFF, and disconnected from the mains.