EN / CZone® Control X User & Installation Manual
2 SAFETY AND INSTALLATION PRECAUTIONS
WARNINGS AND SYMBOLS
Safety instructions and warnings are marked in this manual by the following pictograms:
CAUTION
Special data, restrictions and rules with regard to preventing damage.
WARNING
A WARNING refers to possible injury to the user or significant material damage to the Control X if the
user does not (carefully) follow the procedures.
NOTE
A procedure, circumstance, etc, which deserves extra attention.
USE FOR INTENDED PURPOSE
1. The Control X is constructed as per the applicable safety-technical guidelines.
2. Use the Control X only:
• In technically correct conditions
• In a closed space, protected against rain, moisture, dust and condensation
• Observing the instructions in the installation manual
3. Use of the Control X other than mentioned in point 2 is not considered to be consistent with the intended
purpose. BEP Marine is not liable for any damage resulting from the above.
ORGANIZATIONAL MEASURES
The user must always:
• Have access to the user's manual and be familiar with the contents of this manual
MAINTENANCE AND REPAIR
• Switch off supply to the system
• Be sure that third parties cannot reverse the measures taken
• If maintenance and repairs are required, only use original spare parts
GENERAL SAFETY AND INSTALLATION PRECAUTIONS
• Connection and protection must be done in accordance with local standards
• Do not work on the Control X or system if it is still connected to a power source. Only allow changes in
your electrical system tobe carried out by qualified electricians
• Check the wiring at least once a year. Defects such as loose connections, burned cables, etc. must be
corrected immediately