D-Link AC2600 User Manual

65D-Link DAP-1860 User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server
(i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK. (Windows® 7/Vista® users type cmd in the Start Search box.)
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation,
security settings, and the settings on your router. Some
rewall software programs may block a DHCP request
on newly installed adapters.

D-Link AC2600 Specifications

General

Wireless Standard	IEEE 802.11ac
Ethernet Ports	1 x Gigabit Ethernet
MU-MIMO	Yes
Product Type	Wi-Fi Range Extender
Beamforming Technology	Yes
Frequency Bands	2.4 GHz, 5 GHz
Antenna Type	External antennas
Security	WPA/WPA2
Data Transfer Rate	AC2600 (800 Mbps on 2.4 GHz + 1733 Mbps on 5 GHz)
Maximum Speed	1733 Mbps (5 GHz) + 800 Mbps (2.4 GHz)