D-Link AC3200 Ultra - Dynamic IP (DHCP)

101D-Link DIR-890L User Manual
Section 4 - Conguration - Access Point Mode
Dynamic IP (DHCP)
Select Dynamic IP (DHCP) to obtain IP address information automatically from your Uplink
Router.
Advanced Settings
Host Name: The host name is optional.
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Click Save when you are done.
Device Mode: AP Mode
My Internet
Connection Is:
Dynamic IP (DHCP)
DIR-890L HW:A1 FW:1.10
Settings >> Internet
Host Name: dlinkrouter
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
⌵
Advanced Settings ...
My Internet Connection is:
Dynamic IP (DHCP)
⌵
Save
Internet
Use this section to congure your Internet Connection type.
SettingsHome Management
Device Mode: AP Mode
⌵
COPYRIGHT © 2016 D-Link