102D-Link DIR-890L User Manual
Section 4 - Conguration - Access Point Mode
Static IP
Select Static IP if you wish to assign the access point a static IP.
IP Address: Enter an IP address on the same subnet as your uplink router.
Subnet Mask: Enter the subnet mask used by your uplink router.
Default Gateway: Enter the IP address of your uplink router.
Primary DNS
Server:
Enter the IP address of your preferred primary DNS server, usually the
IP address of your uplink router.
Advanced Settings
Secondary DNS
Server:
Enter the IP address of your preferred secondary DNS server, usually
the IP address of your uplink router.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Click Save when you are done.
Device Mode: AP Mode
My Internet
Connection Is:
Static IP
DIR-890L HW:A1 FW:1.10
Settings >> Internet
Save
SettingsHome Management
Internet
Use this section to congure your Internet Connection type.
Device Mode:
AP Mode
⌵
Advanced Settings ...
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server:
My Internet Connection is: Static IP
⌵
Secondary DNS Server:
MTU: Auto
⌵
COPYRIGHT © 2016 D-Link
To Next Page
Loading...
