DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
When the Open or Shared value is selected, the WEP Encryption settings section is displayed
(the section is unavailable for the wireless network operating modes which support the standard
802.11n):
Figure 90. The Open value is selected from the Network Authentication drop-down list.
Parameter Description
Enable Encryption WEP
The checkbox activating WEP encryption. When the checkbox is
selected, the Default Key ID field, the Encryption Key WEP as
HEX checkbox, and four Encryption Key WEP fields are
displayed on the page. For the Shared authentication type the
checkbox is always selected.
Default Key ID
The number of the key (from first to fourth) which will be used for
WEP encryption.
Encryption Key WEP as
HEX
Select the checkbox to set a hexadecimal number as a key for
encryption.
Encryption Key WEP (1-
4)
Keys for WEP encryption. The access point uses the key selected
from the Default Key ID drop-down list. It is required to specify all
the fields.
You can specify keys containing 5 or 13 symbols (use digits and/or
Latin characters). If the Encryption Key WEP as HEX checkbox
is selected, you can specify only keys containing 10 symbols (the
digits 0-9 and the characters A-F).
Page 97 of 175
To Next Page
Loading...
