D-Link DAP-1522 Xtreme N Duo - D-Link DAP-15 User Manual

12
D-Link DAP-1522 User Manual
Section 2 - Installation
Create a Full MediaBand (5GHz wireless) Network
If you have two DAP-1522 devices and want to create a wireless network with full MediaBand technology you will need to
connect one Wireless Bridge to your router and move the switch on the back panel to “AP”. The second Wireless Bridge will need
to be placed next to your Ethernet-enabled devices and you will need to move the switch on the back panel to “Bridge”.
Auto Mode
If the switch on the back panel of the DAP-1522 is set to “Auto”, the device will wait for 30 seconds, looking for an IP address.
If an IP address is found, it will automatically shift to AP mode. If an IP address is not located, the DAP-1522 will automatically
shift to Bridge mode.