D-Link DAP-1522 Xtreme N Duo - System

35
D-Link DAP-1522 User Manual
Section 3 - Conguration
Save to Local
Hard Drive:
Load from Local
Hard Drive:
Restore to Factory
Default:
Reboot the Device:
Use this option to save the current access point
conguration settings to a le on the hard disk of the
computer you are using. First, click the Save button.
You will then see a le dialog, where you can select
a location and le name for the settings.
Use this option to load previously saved access
point configuration settings. First, use the Browse
control to nd a previously save le of conguration
settings. Then, click the Load button to transfer
those settings to the access point.
This option will restore all configuration settings
back to the settings that were in eect at the time
the access point was shipped from the factory.
Any settings that have not been saved will be lost,
including any rules that you have created. If you
want to save the current access point conguration
settings, use the Save button above.
Note: Restoring the factory default settings will not
reset the Wi-Fi Protected Status to Not Congured.
Click to reboot the access point.
System