D-Link DAP-1522 Xtreme N Duo - System

58
D-Link DAP-1522 User Manual
Section 3 - Conguration
Save To Local Hard
Drive:
Load From Local
Hard Drive:
Restore To Factory
Default:
Reboot The Device:
Use this option to save the current access point
conguration settings to a le on the hard disk of the
computer you are using. First, click the Save button.
You will then see a le dialog, where you can select a
location and le name for the settings.
Use this option to load previously saved access point
conguration settings. First, use the Browse control
to nd a previously save le of conguration settings.
Then, click the Load button to transfer those settings
to the access point.
This option will restore all conguration settings back
to the settings that were in eect at the time the access
point was shipped from the factory. Any settings that
have not been saved will be lost, including any rules
that you have created. If you want to save the current
access point configuration settings, use the Save
button above.
Click to reboot the bridge.
System