D-Link DAP-1522 Xtreme N Duo - Networking Basics; Check Your IP Address

88
D-Link DAP-1522 User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a
DHCP server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK.
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation,
security settings, and the settings on your access
point. Some rewall software programs may block a
DHCP request on newly installed adapters.
If you are connecting to a wireless network at a hotspot
(e.g. hotel, coee shop, airport), please contact an employee or administrator to verify their wireless network settings.