D-Link DAP-1522 Xtreme N Duo - D-Link DAP-15 User Manual; Wireless Settings

24
D-Link DAP-1522 User Manual
Section 3 - Conguration
Wireless Mode:
Enable Wireless:
Wireless Network
Name:
802.11 Band:
802.11 Mode:
The current wireless mode is set to Access Point, it will
create a wireless infrastructure network.
Check the box to enable the wireless function. If you do
not want to use wireless, uncheck the box to disable all
the wireless functions.
When you are browsing for available wireless networks,
this is the name that will appear in the list (unless
Visibility Status is set to Invisible, see below). This name
is also referred to as the SSID. For security purposes, it is
highly recommended to change from the pre-congured
network name.
Operating frequency band. Choose 2.4GHz for visibility
to legacy devices and for longer range. Choose 5GHz for
least interference.
If you choose 2.4GHz band, than select one of the
following:
Mixed 802.11n, 802.11g and 802.11b - Select if you are
using a mix of 802.11n, 11g, and 11b wireless clients.
802.11b Only - Select if you are only using 802.11b
wireless clients.
802.11g Only - Select if you are only using 802.11g
wireless clients.
802.11n Only - Select if you are only using 802.11n
wireless clients.
Mixed 802.11g and 802.11b - Select if you are using a mix of 802.11g and 11b wireless clients.
Mixed 802.11n and 802.11g - Select if you are using a mix of 802.11n and 11g wireless clients.
If you choose 5GHz band, then select either 802.11a Only, 802.11n Only, or Mixed 802.11n and 802.11a.
Manual Conguration
Wireless Settings