16D-Link DCS-2310L User Manual
Section 1: Product Overview
Reattaching the Bottom Panel
Step 1:
Seat the protective panel in place and ensure a tight t with the inlaid rubber seal.
Step 2:
Replace the two screws. Ensure that the screws are tightened rmly.
Step 3:
Firmly replace the protective rubber screw coverings.
Note: To ensure that the camera stays weatherproof, users are advised to ensure that all the
rubber seals are secured rmly in place.
Installing an SD Memory Card
Step 1:
Follow the steps outlined in "Removing the Bottom Panel" on page 15.
Step 2:
Insert a MicroSD Memory card into the slot, with the notch facing right.
Step 3:
Follow the steps outlined in "Reattaching the Bottom Panel" below.
2
2
3
4
To Next Page
Loading...
