D-Link DCS-933L Cloud Camera 1150

17D-Link DCS-933L User Manual
Section 2 - Installation
To create a WPS connection:
Step 1
Make sure the camera is powered on, then press and hold the WPS button or
three seconds. The blue WPS status LED will start blinking.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is
usually located on the ront or side o your router. On some routers, you may
need to log in to the web interace and click on an on-screen button to activate
the WPS eature. I you are not sure where the WPS button is on your router,
please reer to your router’s User Manual.
The DCS-933L will automatically create a secure wireless connection to your
router. While connecting, the green LED will fash and your camera will reboot.
WPS - Push Button Setup
WPS Button
Alternatively, you may create a secure wireless connection using the WPS Button on the back o the camera.