D-Link DCS-933L - Network Setup

24D-Link DCS-933L User Manual 24
Section 3 - Conguration
Network Setup
Select this connection if you have a DHCP server running on your network
and would like a dynamic IP address to be updated to your camera
automatically.
You may obtain a static or xed IP address and other network information
from your network administrator for your camera. A static IP address will
ease you for accessing your camera in the future.
IP Address: The xed IP address
Subnet Mask: The default value is “255.255.255.0.” Used to determine if
the destination is the same subnet.
Default Gateway: The gateway used to forward frames to destinations
in a dierent subnet. Invalid gateway settings may cause the failure of
transmissions to a dierent subnet.
Primary DNS: Primary domain name server that translates names to IP
addresses.
Secondary DNS: Secondary domain name server to backup the Primary
DNS.
IfyouareusingaPPPoEconnection,enableitandentertheUserName
andPasswordforyourPPPoEaccount.Youcangetthisinformationfrom
yourInternetserviceprovider(ISP).
You may congure a Second HTTP port that will allow you to connect to
the camera via a standard web browser. The port can be set to a number
other than the default TCP ports 80. A corresponding port must be opened
on the router. For example, if the port is changed to 1010, users must type
http://192.168.0.100:1010 instead of only “http://192.168.0.100”.
Enablethis setting tocongureyourcameraasa UPnPdeviceinthe
network.
DHCP:
Static IP Client:
PPPoE Settings:
Port Settings:
UPnP Settings:
This section allows you to congure your network settings.