41D-Link DCS-936L User Manual
Section 3 - Conguration
IP Filter
The IP Filter is a feature used to allow or deny certain IP addresses when accessing the DCS-936L. Please note that when creating an allow list, if the
IP address of your computer is not included or if you do not set up an administrator IP address, you may be locked out of accessing your camera. In
this event, you will need to do a hard reset of your camera by pressing the reset button for more than 10 seconds while it is powered on.
Access List
Filtering:
Filter Type:
IPv4 Filter List:
IPv6 Filter List:
Add New Filter.
Administrator
IP Address.
Check this box to enable the IP Filter function.
Select whether to set the lter to allow or to deny connection from the IP
addresses listed.
The current list of IPv4 addresses that are being ltered. Select a line and
the click the delete button to remove that entry.
The current list of IPv6 addresses that are being ltered. Select a line and
the click the delete button to remove that entry.
From the drop down menu, select whether to add a single IP, an entire
subnet, or a range of IP addresses. Enter an IP address, subnet, or IP range,
then click Add to create a new lter.
You can allow a single IP address to always have access to this camera,
regardless of the IP lter rules being used, by enabling this option and
entering the IP address.
Click Save Settings to save your changes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
