D-Link DES-3550 - Forwarding Database Commands

DES-3550 Layer 2 Fast Ethernet Switch
11
FORWARDING DATABASE COMMANDS
The layer 2 forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
create fdb <vlan_name 32> <macaddr> port <port>
create multicast_fdb <vlan_name 32> <macaddr>
config multicast_fdb <vlan_name 32> <macaddr> [add | delete] <portlist>
config fdb
aging_time
<sec 10-1000000>
delete fdb <vlan_name 32> <macaddr>
clear fdb [vlan <vlan_name 32> | port <port> | all]
show multicast_fdb {vlan <vlan_name 32> | mac_address <macaddr>}
show fdb {port <port> | vlan <vlan_name 32> | mac_address <macaddr> |
static | aging_time}
config multicast
port_filtering_mode
[<portlist> | all] [forward_all_groups |
forward_unregistered_groups | filter_unregistered_groups]
show multicast
port_filtering_mode
{<portlist>}
Each command is listed, in detail, in the following sections.
109