DES-3550 Layer 2 Fast Ethernet Switch
7
NETWORK MANAGEMENT (SNMP) COMMANDS
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
The DES-3550 supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. You can specify which
version of the SNMP you want to use to monitor and control the Switch. The three versions of SNMP vary in the level of
security provided between the management station and the network device. The following table lists the security features of
the three SNMP versions:
SNMP
Version
Authentication Method Description
v1 Community String Community String is used for
authentication − NoAuthNoPriv
v2c Community String Community String is used for
authentication − NoAuthNoPriv
v3 Username Username is used for
authentication − NoAuthNoPriv
v3 MD5 or SHA Authentication is based on the
HMAC-MD5 or HMAC-SHA
algorithms − AuthNoPriv
v3 MD5 DES or SHA DES Authentication is based on the
HMAC-MD5 or HMAC-SHA
algorithms − AuthPriv.
DES 56-bit encryption is added
based on the CBC-DES (DES-56)
standard
Command Parameters
create snmp user <username 32> <groupname 32> {encrypted [by_password auth
[md5 <auth_password 8-16 > | sha <auth_password 8-20 >] priv [none |
des <priv_password 8-16> ] | by_key auth [md5 <auth_key 32-32>| sha <auth_key
40-40>] priv [none | des <priv_key 32-32> ]]}
delete snmp user <SNMP_name 32>
show snmp user
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 32> [all | oid]
show snmp view <view_name 32>
create snmp community <community_string 32> view <view_name 32> [read_only | read_write]
delete snmp community <community_string 32>
show snmp community <community_string 32>
33
To Next Page
Loading...
