DES-3550 Layer 2 Fast Ethernet Switch
20
LIMITED IP MULTICAST ADDRESS
The Limited IP Multicast command allows the administrator to permit or deny access to a port or range of ports by specifying
a range of multicast addresses. The Limited IP Multicast Commands in the Command Line Interface (CLI) are listed (along
with the appropriate parameters) in the following table.
Command Parameters
<portlist> { from <multicast_ipaddr> to <multicast_ipaddr>
access [ permit | deny] | state [enable | disable ] }
[ all | <portlist> ]
show limited multicast address { <portlist> }
config limited multicast address
delete limited multicast address
172
To Next Page
Loading...
